The automatic baler has the characteristics of good rigidity and stability, beautiful appearance, convenient operation and maintenance, safety and energy saving, and low investment cost of equipment basic engineering. It is widely used in various waste paper factories, old waste recycling companies and other units and enterprises. It is suitable for packaging and recycling old waste paper, plastic straw, etc. It is an equipment that improves labor efficiency, reduces labor intensity, saves manpower, and reduces transportation costs.
With the development of society and the continuous improvement and progress of automatic packaging machines in packaging machinery, there are great changes in equipment and performance. In the future, there will be great development potential, which will bring more benefits and convenience to packaging companies and bring new business opportunities.
We will talk about so much about the automatic baler first. If you have more knowledge about the baler, please log in to our website and leave a message for consultation. We will have staff answer your questions, don’t miss it!
Fault one, the baler accessories are excessively fused or broken during the fusion process
Reasons: 1. The thickness of the baler accessories is not enough;
2. The fusion time is not long;
3. The cooling time of the friction fusion part is too short
Solution:
1. Use the correct specifications of the baler accessories, or adjust the baler according to the specifications of the baler accessories;
2. Shorten the fusion time as needed;
3. After fusion, keep it for 3 seconds. After fusion, the baler cannot be removed from the baler accessories.
Fault two, fusion is incomplete or not fused
Solution:
1. Press and hold the reversal valve to release the tension of the baler accessories;
2. To operate the tensioner, the tensioner is connected to the exhaust valve, and then the shut-off valve is opened.
During the maintenance of the baler, we need to do a good job of inspection before use. Check whether the working pressure of the baler is normal; when the air pressure drops, the cutting force of the steel belt comes from the blockade of the cylinder. See the fault phenomenon; when checking the blockade operation, the tension on the lock clamp is insufficient
So what is the reason? Generally, it is because of the wear of the clamping block coupling hole or coupling pin. Then we can check these parts when the groove depth is shallow, and replace them if necessary. Of course, there is still a lot of knowledge about the maintenance of the packer. Some common small faults can be solved. When you can't solve it, you can also find a technician to check the problem.
13915763435
